AeroControlex is pleased to announce that AAR Supply Chain Inc. will now act as the exclusive world-wide distributor for the APU lube pump products.

Ball Bearing Control Cable Guidelines

Series	300	400	500	600
*Normal Duty:	75 lbs.	100 lbs.	150 lbs.	500 lbs.
*Limited Duty:	150 lbs.	200 lbs.	300 lbs.	1000 lbs.
Bend Radius	6 in. 4 in.	7 in. 4 in.	7 in. 4 in.	7 in. 4 in.
Weights	Approx. 0.14 lb/ft	Approx. 0.19 lb/ft	Approx. 0.31 lb/ft	Approx. 0.50 lb/ft
Temperature Range	Bare casing (M): -65 F to +450 F Vinyl covered casing (MV): -20 F to +350 F
Lubrication	Not required
Flexibility	Multi-plane bends allowable
Test Requirements	MIL-C-7958, MIL-STD-810
Efficiency	90-98%
Materials	CRES (Stainless Steel) / Vinyl (covering)
Length (a)	Minimum 30 inches
Support Clamping	Recommended every 3 feet
Maintenance	None required
Shipping & Storage	Figure "8"(b)
*Loads Maximum recommended tension & compression (a) Lengths greater than 50 ft. will be supplied in (2) or more equal lengths with appropriate couplings. (b) Control cables are best shipped and stored in the figure "8" configuration received from the factory. This minimizes the possibility of damage. Normal duty assumes a minimum product life of 100,000 cycles. Rated compression loads are limited to 4 inch maximum stroke. Duty cycles greater than 100,000 cycles can be achieved with increased bend radii on the control.

The basic specifications for each of the control series are defined on the accompanying capabilities chart. This chart shows the basic operational characteristics for each of the control series. Load carrying capability and bend radius are the distinguishing operating characteristics between series.

The standard configurations described on the following pages accommodate applications where input and/or output actions have straight push-pull motion. Where an arc articulation is required, a ball joint connector is recommended (See Accessories for selection). Rigid mounting of control cable end fittings is achieved with jam nuts and washers on the threaded portions of the main sleeves.

When required by a specific application, a number of options are available for sealing the control from the environment.